Motion Control – 510 Series DC and Brushless Servo Motor Drivers from MotiCont!

Motion Control – Servo Motor Drivers

motion control - servo motor driversVan Nuys, CA – Motion Control – This series of drivers is a high performance, cost effective servo motor driver to implement intelligent motion control. The driver incorporates an advanced architecture and surface mount technology to achieve an exceptional power density. This series is designed to drive voice coil, brush-type and brushless DC motors at a high switching frequency. They receive step and direction signals or analog signal from motion controller.
motion control - moticont

There 3 models of the 510 Series DC and Brushless Servo Motor Drivers:

510-01 Servo Motor Driver,up to +80 VDC Power Supply, 12 Amps Maximum Currentt

510-02 Servo Motor Driver,up to +80 VDC Power Supply, 20 Amps Maximum Current

510-03 Servo Motor Driver,up to +80 VDC Power Supply, 40 Amps Maximum Current
Features of 510 Series DC and Brushless Servo Motor Drivers:

  • Runs DC and Brushless Servo Motors
  • Four Quadrant Regenerative Operation
  • Space Vector Modulation (SVM) Technology
  • Fully Digital State-of-the-art Design
  • Programmable Current, Velocity and Position Loops Gain Settings
  • Fully Configurable Current, Voltage, Position Limits
  • PIDF Velocity Loop
  • PID + FF Position Loop
  • 12 Amps Motor Output
  • +20 VDC to +80 VDC Power Supply
  • Protected Against Over Current
  • Built-in Signal Generator, Sinusoidal, Square Wave and Triangular
  • 20 KHz PWM Frequency
  • No Tachometer Feedback Needed
  • 0 ºC to 70 ºC Operating Temperature
  • Modular 2-Piece Power, Motor, Signal Connector

510 Series DC and Brushless Servo Motor Drivers Modes of Operation:

  • Current
  • Velocity
  • Position

Command Source for 510 Series DC and Brushless Servo Motor Drivers:

  • Encoder Following
  • 10 V Analog
  • Step and Direction

Feedback Supported by 510 Series DC and Brushless Servo Motor Drivers:

  • Incremental Encoder
  • 10 V Analog
  • Auxiliary Incremental Encode

To order 510 Series DC and Brushless Servo Motor Drivers online Click Here!

For additional information contact MotiCont, “A Motion Company” at 6901 Woodley Avenue, Van Nuys, CA 91406, USA; Tel: , Fax: (818) 785-5713, E-Mail: moticont@moticont.com or visit the website at http://www.moticont.com


See this and other Motion Control Components from Moticont featured on:

http://MotionShop.com.com

http://AllMotionBlogger.com

http://Automation-Blogger.com

http://MotionControlBlogger.com

http://motioncontrolBuyersGuide.com

http://MotionControlWeb.com

http://MotionShop.net

http://Catalogs-MotionControl.com
motion control - moticont